Welcome to EcoFlow Support
We're here for you
Recommended Search

We're here for you
Recommended Search
1. Ensure that the solar panel is installed outdoors. Panels installed indoor without sunlight exposure will not be able to charge portable power stations. 2. Check whether the connection cable has been properly connected according to the instructions, and re-plug it to confirm. 3. Check whether the solar panel input voltage and current match the specifications of the solar input parameters of the portable power stations, and check whether the positive and negative terminal connections are reversed. 4. Check whether any alarm message is shown on the display of the portable power stations, and troubleshoot it as instructed. 5. If the solar panel still does not work properly after the above steps, use the XT60i port to connect the portable power station to the car charger port to confirm whether the charging cable is working properly. 6. Contact after-sales service for help and send a video of the steps you have carried out.
When storing the solar panel, please fold the solar panels and then put them in the bag with the lead-out wire of the junction box facing upward.
This depends first and foremost on weather conditions. Generally speaking, on a clear day with no clouds in the sky, sunlight hitting the panel at a 90° angle usually generates 70 W–80 W of power in the 100 W panel (current light conditions are normally 800–900 W/m2 (74.3–83.6 W/ft2) with a panel temperature of 50°C (32°F) under test conditions. Nominal power ratings are based on 1,000 W/m2 (92.9 W/ft2) in AM1.5 conditions with a panel temperature of 25°C under test conditions. Power output figures close to nominal values were normally observed in the midday sun during the winter).
The operating temperature range of the solar panel is -20°C to 85°C (-4°F to 185°F). Please read the instructions carefully before using the solar panel and minimize large bends during use to avoid damage to the battery core. The panels are made of a special composite material, which is lightweight and able to bend to a certain degree,allowing them to be used flexibly on different surfaces of the roof. However, the solar panels are made of monocrystalline silicon wafers, and despite their flexibility, they should not be slammed on the ground during installation and use or stepped on or struck with foreign objects. Do not sit on the surface of the panels and do not bend the panels too far in order to prevent the monocrystalline wafers from breaking and affecting use. Damage caused by human force is not covered under the free warranty.
The solar panel can be bent on certain surfaces, but the more the panel bends, the less efficient it is. This is because panel power generation is best only when the entire panel has a consistent light source. When bent, different areas of the flexible solar panel are exposed to different amounts of light, reducing power generation efficiency.