Welcome to EcoFlow Support

Welcome to EcoFlow Support

We're here for you

FAQ

Unable to map

Use the remote control to move BLADE to the start point and start mapping again Reduce the distance between the start and end points to less than 1 m Use the remote control to move BLADE to the start point and start mapping again

BLADE unable to obtain the best satellite signal

Install the GNSS antenna in a location where there is nothing to block the signal Connect the GNSS antenna to the charging station correctly Check the condition of the charging station cable Please ensure that BLADE and the GNSS antenna are close enough to one another

Abnormal cooling

1. Check that the mode and temperature are correctly configured. 2. Use the device within the operating temperature range. Higher ambient temperatures will lead to greater working loads and compromised cooling effect. 3. Remove any blocking objects and make sure that the air inlet is more than 0.5 m from walls. 4. Connect the device to the Ecoflow app and complete network setup. Then check for any firmware updates. 5. Refer to the user manual and use the device within the specified temperature range. 6. Check the device's cooling effect after the protective shutdown period ends.

What should I do when the container is full?

When the container is full, the app will prompt that "Fallen leaves container is full. Please clean it timely". Please manually empty the leaves in the container, so that the mower can continue the cleaning task.

The rain detection triggered and my robotic lawn mower returns to the charging station even if it's not raining. Why?

1. Please regularly check whether there are foreign substances above the rain sensor. Please remove any foreign substance (if any) with a small brush; 2. If the sensor still cannot work normally after the foreign substances are removed, please contact the after-sales service for troubleshooting

Contact us