Welcome to EcoFlow Support
We're here for you
Recommended Search

We're here for you
Recommended Search
1. If it is charging from an AC outlet, confirm that the AC switch is turned on. The same goes for DC outlets. 2. If the AC or DC switch is turned on, and it still cannot be charged, please confirm whether the output power of the power station meets the wattage requirements of your device 3. When the power from a DC source and car charger is less than 1 watt, the charging power will not be displayed. 4. When the screen displays an overload alarm, it means that the charging power is too high. Please shut down and cool down for a while or try using a low-power device, then try charging again (for example, shut down and cool the power station for 30 minutes and restart, if there is still an overload prompt, please provide a screenshot or video and contact support.eu@ecoflow.com 5. The AC switch will turn off after 12 hours if the power of the electrical appliance is less than 10W because the power detection is equivalent to having no power output. At this time, the switch needs to be turned on again.
1. Make sure that the battery setting function in the app is set to 100%. You can set this in the app. 2. Perform SoC calibration three times by fully discharging and charging the battery..
Apart from the home grid, car charger, and solar panel, you can also charge RIVER Pro with a generator or inverter as long as it can provide 220-240V (50Hz/60Hz) AC power, and it should be a pure sine wave. While charging RIVER Pro, you should ensure that the AC input power is higher than 800W. If slow charging is enabled, ensure that the input power is higher than 140W.
It means it can act as an emergency power supply (EPS). When your unit is plugged into the wall, anything plugged into it gets power from the grid, not its battery. If power from the grid stops, the unit automatically switches to its battery supply mode within 30 milliseconds. That means anything connected will not have power for 30 milliseconds. Desktop computers and data servers will turn off in this 30ms window. It is recommended that only one device is plugged in to avoid overloading.
1. When charging or discharging, it charges/discharges the one with low voltage first, then the battery itself (device) and then it charges/discharges the extra battery and main unit at the same time.