Welcome to EcoFlow Support
We're here for you
Recommended Search

We're here for you
Recommended Search
Yes, we recommend connecting 2 same units in series at most. Furthermore, please also note: 1. The slave unit must be fully charged before being connected. 2. Must not charge the main unit when the slave is connected.
Yes, but please note: - The transfer switch should be connected to the power station's AC output port; - You should disconnect the circuits from the grid before they are supported by the power station; - The total power consumption of the circuits should not exceed the output power rating; - The output will not be grounded if the power station is not connected to the grid.
1. To prolong the battery life, we recommend that you use and store the product in an environment of 20°C to 30°C, away from water, heat, and metal objects. 2. For long-term storage, discharge the product down to 30% and then charge it up to 60%. Continue to follow this procedure every 3 months. Units that are not charged and discharged for more than 6 months will no longer be covered under warranty. 3. For safety reasons, please do not store this product in an environment above 45°C or below -10°C over a long period.
So far, DELTA Pro/Smart Home Panel/Solar Tracker have a bluetooth module and can connect to the app via bluetooth. Other models without bluetooth can connect to the app via IOT or Direct Connection.
We do not have an official solution for wind turbine charging yet. However, a DIY solution is possible at your own risk. (As long as wind power meets our input XT60 port and AC inlet requirements of the power stations)